Plug in the old module again then follow process below – Issue the ‘no module x’ command, where x is the letter of the slot (A through L).The following warning will be displayed:This command will shut down the specified modules and remove all configuration settings for those modules and their ports. Any management traffic for Read more about Orange flashing light after changing module on 5400R zl2[…]
The delete file command moves a file to the recycle bin. To restore the file, use the undelete command. If you delete two files with the same file name in different directories, only the last one is retained in the recycle bin. The dir /all command displays the files moved to the recycle bin. These files are Read more about Permanently Delete Files On HP Switches[…]
First up if you dont already download a free TFTP Server – recommend this one http://www.solarwinds.com/products/freetools/free_tftp_server.aspx Install and note IP address of machine installed on. For example here its 10.1.1.10 Log on to your switch… First, we will take a look at what version of firmware the switch shipped with (and already exists, therefore, on flash): Read more about Update HP Procurve Firmware[…]
Simple overview of how to setup SNTP on a HP Procurve switch, you will find out the box on every restart the time will reset and then when looking at the logs your job just became alot more difficult. First up telling the switch which time protocol we are going to use. We will use Read more about HP Procure Series How To Set a Time Source using SNTP – Time Server Synchronisation[…]